How to SET the Master Mode of ReatogoLogon :

Follow the steps below to change the master mode.  

 

   

Per default ReatogoLogon is set to "STANDARD MODE"

... after the automatic firstrun configuration, because many users will not need boot profiles and multible shells for a start.

 

Set it to "EXPERT MODE"

... as shown below, to enable the full potential and the great flexibility ReatogoLogon offers.

 

The two Master Modes of ReatogoLogon
STANDARD MODE EXPERT MODE

Boots you straight into the Explorer shell. Boot profile no. 3 will be silently executed.

You won´t even notice that ReatogoLogon is there.

ReatogoLogon is fully active and the Boot Profile selection and Shell Selection prompts allow you to control the boot process.

Password prompt works in any case if password protection is configured. You can also in both modes switch between shells with Ctrl-Alt-End AFTER you are fully booted (if you have multible shells on CD).

The procedure below makes these changes:

in: PEroot\OEM1\reatogo_logon\Reatogo-Logon.inf

SILENTBOOT=1

AUTOLOGONTIMEOUT=0

BootProfileTimeout=0

SILENTBOOT=0

AUTOLOGONTIMEOUT=5

BootProfileTimeout=10

in PEroot\plugin\AUTOHELP\Settings.ini:

SilentBoot_Profile3=1

SilentBoot_Profile3=0
   

 

Changing the Master Mode:

 

Click

"Configure My Defaults"

on the Reatogo main panel.

 

That will start the popup

"Configure My Defaults".

   

 

 

 

 

 

 

 

Click

"Configure My Defaults"

(Full Wizard run with prompts)

 

There will be various prompts for wallpaper, screen resolution etc. ... until you get to the

ReatogoLogon "Master Mode Selection"

 

   

 

 

Info popup

 "STANDARD MODE - EXPERT MODE"

 

 
   

DoubleClick the mode you want.

At the end of the following run your ReatogoLogon module will be set to the mode you selected.