|
Slipstream Servicepack using PEbuilder :
Use this 3-step-method if you just want to create a valid source for PEbuilder. It is quite simple. You basically only have to copy the content of your Windows setup CD into a folder on your harddrive, put the servicepack-EXE into the same folder and let PEbuilder merge the two. Follow the step-by-step instructions below.
NOTE: the screenshots show older versions of PEbuilder and the reatogo setup. But the method is the same with the current versions. |
|
|
|
Step 1
Prepare your source folder
Create a new folder
"XPsp2" in the root of your Reatogo setup.
Follow the instructions below, to integrate both.
When done, specify the folder "XPsp2" as your source for PEbuilder.
|
 |
|
|
|
|
Step 2
Select the slipstream mode of PEbuilder |
|
|
|
|
|
Step 3
Point PEbuilder to:
1.) the source (the folder with the copy of the content of your setup-CD)
2.) the ServicePack-EXE (in the same folder where the copy of the content of your setup-CD is)
Press OK to start the slipstreaming. |
 |
|
|
|
|
progress info ... |
 |
|
|
|
|
progress info ... |
 |
|
|
|
|
Slipstreaming is finished. Press "OK". |
 |
|
|
|
|
DONE
Press "Stop" to exit the slipstream mode of PEbuilder. |
 |
|
|
|
|
now specify the folder "XPsp2" as your source for PEbuilder :
All set ... |
 |
